on 06-19-2014 7:45 AM
Hi All,
I have seen a lot of these questions coming by in the forum but all those answers worked for many of you does not solve my problem with this.
I tried running the RSA1, it didn't give me a popup so tried to activate and replicate it manually, but that fails (although in RSA1 it says OK)
RSCTO_ADMIN tcode running the start button gives me an error.
Error through Solman_setup:
| A failure occured while calling CCMSBI_RUN_SETUP_IN_BTC at ABAP Host=localhost sys=00 client=400 admUser=SOLMAN_ADMIN rfcUser=SMD_RFC | |||
| A failure occured while calling CCMSBI_RUN_SETUP_IN_BTC at ABAP Host=localhost sys=00 client=400 admUser=SOLMAN_ADMIN rfcUser=SMD_RFC !! Exception : BI_NOT_READY(Abap cause=nullnullnullnull) | |||
| com.sap.mw.jco.JCO$AbapException: (126) BI_NOT_READY: BI_NOT_READY |
When running the rscto_admin
It comes with an error (see screenshot)
Username password incorrect (try again)
Any ideas on this?
Try to start with SAP KBA 2005507 - Exception "BI_NOT_READY" in Solution Manager 7.1.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi All,
One more tips, i had a same problem after system migration. I did all your suggestions (Role assignment etc..)but no luck.
Even if you don't get popup once enter the RSA1 T-code don't go back, in same page Goto -> Source system -> Right click Source system name in right side -> and click Activate. You will get error message if your source system not connected properly, then follow the error message.
My case Source system RFC is not working due to wrong Host and User name entry. Finally i changed right one and all went well.
Regards,
Vino
Hi,
Kindly Check the below mentioned note :
2005507 - Exception "BI_NOT_READY" in Solution Manager 7.1
also check below thread these will solve your issue .
http://scn.sap.com/thread/2068975
Thanks & Regards,
Sandeep Alapati
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandeep
Checked both, but as I said RSA1 doesn't give me the solution like all others got.
Tried activating it manually there it tells all ok but setup bw still runs into the error, rstco_admin gives me the error on wrong user name password.
Trying to look at the dataobjects, I cannot find them in RSOR
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.