on 06-16-2014 12:58 AM
We started to set profile settings Solman. And exposing those or other parameters that would minimize the maximum swap, it turns out that the load on the I/O is too high and the system starts to slow down greatly. Promt, who faced what better profile settings set to what value?
Hi Evgeniy,
PLs refer below notes for profile parameter,
1582842 - Profile parameters for SAP Solution Manager 7.1
Regards
K.N
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
There is an OSS note for some basic parameter, refer this note 1582842 - Profile parameters for SAP Solution Manager 7.1
But again you need to make your own decision for few parameter value for abap/buffersize etc. (may go for 800 MB or 1 GB based on your current system)
regards
Swami
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
same problem with our solman SP11, it takes ages to start and the CPU is alwasy 50% used. I am trying to investigate what causing the CPU and slow start.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.