Web Dynpro Built-In not available after enhance on Start Configurator of a WD Component

[pedro_santos6]

Hello everyone,

I´m trying to create a enhancement on my start configurator of my web dynpro component.

This is the information of my system:

I select the wd component and set the Start Configurator to create a new enhancement:

After create the enhancement my web dynpro built-in option is not available to change data:

Any idea why the web dynpro built-in is not available?

Rgs,

Pedro Marques

[jerry_martinek2 · Accepted solution]

Hi Pedro,

Did you figure out why the Web Dynpro Built-In disappears once you create the enhancement?

I have the same question. I'm trying to remove the item level approval tabs without enhancing the associated WDC.

So far I can only use the Comp Conf enhancement when removing the header level approval tabs for the WDC FPM_OIM_COMPONENT.

Thanks,

Jerry

[pedro_santos6 · Accepted solution]

Hello Jerry,

I could not perform in the same old way.

But you can do that:

Rgs,

Pedro Marques