Sequence dependent setup activity does not have a mode

[former_member476084]

Hi,

We are facing a problem in production when converting the planned order to process order.When conversion indicator is set in APO, the key is moving to ECC creating a process order but the process order is not moving to APO.The inconsistencies were found in CPP and CCR.In CPP the error is showing as "Sequence dependent setup phase does not have a mode" . There were no recent changes done in resources and PDS.

Since our Quality is refreshed every month I tried to replicate there but when i  convert a planned order to process order it was working there.I compared the PDS and resources in quality in production but there was no difference.

Please suggest what else should I search to find the root cause .

Thanks

Debasis Nanda

[former_member182332 · Accepted solution]

Hi Debasis,

Kindly check if "determine capacity reqrements" is set for the order, Because most of the times this issue occurs due to no generation of capacity requirements.

Hope this helps

BR

Gomathi

[former_member182332]

Hi,

Kindly check the below steps:

1) Check if the note 863509 is imeplemented in your system, and very importantly the exit is implemented properly and activated so that it is called during the order transfer

2)In case you have a scenario where a new material is added during production then in that case that material needs to be assigned to an activity, it shouldnt have an dummy acitivity.

BR
Gomathi