on 05-27-2014 3:26 PM
Hello,
Can some explain what to do under the below given circumstances?
Attention: Critical Memory Status! p10 80% memory
System: SID
Program run from: 27.05.2014 15:45:21
Threshold Roll Area: 80.00 %
Threshold Paging Area: 80.00 %
Threshold Extended Memory: 80.00 %
Instance Role Area Paging Area Extended Memory
-------------------------------------------------------------------------------------------------------------------------------
sapxxxxx_SID_01 5.66 14.36 89.35
Thanks,
uday
Hello Uday,
you have to check, what has consumed this memory and if you can increase values for some memory parameters. Please check ST22 for memory dumps, and please check ST02 (history for extended memory and heap), if the instance regularly consumes this amount of memory. Which operating system and which basis/kernel release has the system?
regards, Alwina
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Alwina,
Thanks for the reply.
SAPKB70027 - Basis component
SAP Kernel : 720_EXT_REL
Kernel Patch number : 420
Dump "TSV_TNEW_PAGE_ALLOC_FAILED" occured once today.
What happened?
You attempted to extend an internal table, but the required space was
not available.
Error analysis
The internal table "\FUNCTION-POOL=SKBH\FORM=FB_SUBTOTALS_GET\DATA=<IT_HTAB>"
could not be further extended. To enable
error handling, the table had to be delete before this log was written.
As a result, the table is displayed further down or, if you branch to
the ABAP Debugger, with 0 rows.
At the time of the termination, the following data was determined for
the relevant internal table:
Memory location: "Session memory"
Row width: 2156
Number of rows: 45523
Allocated rows: 45523
Newly requested rows: 4 (in 1 blocks)
Thanks and best regards,
uday
Hello Uday,
this instance can allocate around 42GB extended memory, the instance has used maximum around 9,5GB memory since last restart, so this instance did not use 80% memory like you have posted originally. Is this ST02 output from the correct instance (just to be sure)? In ST02 --> Environment --> RFC server you can switch between instances, could you please check, if you have the output from the instance sapxxxxx_SID_01 like in your original post?
regards,
Alwina
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.