on 05-24-2014 4:55 PM
Hi,
There is negative WM stock in storage type 914. Now we want to remove this stock from 914 St. type.
We are using production planning and warehouse management integrated system.
What is the correct method for removing this negative stock without affecting stock change in inventory management.
Can we do it manual transfer posting from St. type 914 to other stoarge type. If yes then which movment type shall be use.
In future how can we avoid this. Please explain.
We have attached a snap shot of warehouse stock for your reference.
Thanks & Regards,
Ranjeet
Hi Ranjeet,
From above screen shot I can see you have negative stock.
Please check physical stock in your wh for that mat.
Then check LX02 for same mat across storage type,
then check MMBE/MB52 and if there is a difference then need to do PI.
If there is no difference then from LX02 you can find actual place where stock is located and where is disturbances.
Take your decision and go forward.
At all time you need to check no open TO should be present for that MAT.
Regards
Suraj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
Go to LL01 Warehouse Monitor and redetermine the data. Then clear all the open Transfer Requirements and Posting changes. That should clear most of your Negative stocks. If you still find. Carry out physical inventory for those components then, Do bin-to-bin transfers for adjustments. If you still end up with negative stocks, then clear those using LI21.
Regards,
Sathish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.