Managed System Configuration (Step 7) Byte Code Adapter Installation Failing

[Former Member]

All other steps proceeding has completed successfully, the dev system has succeeded. All software version appear ok. Checked the forums for similar issue. Cannot figure out the problem. Can anyone help please?

Logs showing the following entries.

Any ideas?

[Former Member · Accepted solution]

Please check if SAP KBA 1848739 - Managed System Configuration - Byte Code Adapter Setup fails with java.lang.NullPointerExc... is relevant to your issue.

[Former Member · Accepted solution]

Thanks Jansi and Roman,

The issue was fixed by

chmod -R g+rX /usr/sap/<Managed_System_SID>/<Instance_ID>/work

chmod -R g+rX /usr/sap/<Managed_System_SID>/<Instance_ID>/j2ee/cluster

As per OSS Note 1848739 (Which points to note 1163751 )

Regards

Tariq

[Former Member]

Hi,

your wily agent is not running, hence the byte code agent configuration step fails in managed system configuration.

make sure you installed wily and started. Check in BASIS configuration -> step 3 configure CA intro scope. is it green?

- follow the sap note Note 1565954, wily 9 setup guide to install the ISAGENTS.

- apart from that make sure you have latest LM_Service updated version

- I saw some of the remote operation failed error, make sure you have enough authorization for the user connecting java host, normally it should be admin user, maintained in step 5 of managed system configuration.

- if you already installed also, try to uninstall and re install.

Thanks

Jansi