Check Configuration Step fails with error "Managed System <SID>~JAVA is not configured

[Former Member]

Hi,

When completing the Check Configuration step 10 in managed systems setup I am getting the following error message. All other steps previous are green and successful. Any suggestions please? Error message details are as below.

[tanmeya_mohan · Accepted solution]

Hi Tariq,

Please check the following -

Is the Java system correctly configured in SLD & pushing current data to SLD periodically.

This usually deals with RFC(s) SLD_DataSupplier & SLD_Client, followed by manual collect & send data.

Check in LMDB, that correct entries are maintained for hostname & FQDN for this server's database host (might be an issue if entry was manually created).

Also check if the verification check of the Product System in LMDB is green.

Also check if correct time zone settings are maintained (using transaction STZAC iff this server has an ABAP stack as well).

Also as highlighted in the logs, did you get a chance to view below SAP Note -

1647267 - Solution Manager adaptation to Java UME security

Regarding SMD agent, it is always recommended to use the latest version. After installation, you would need to register the same in SLD & with SolMan system using below SAP Notes -

1913837 - How to connect Diagnostics Agent to SLD by using smdsetup script

1907909 - How to connect Diagnostics Agent to Solution Manager system directly by using smdsetup scr...

Try these & check if there is any change to the error.

Best Regards,

Tanmeya

[Former Member · Accepted solution]

Hello Tanmeya,

Thanks for your suggestion, I have reviewed your suggestions in detail.

SLD is correctly configured. LMDB contains FQDN's. Verification is successful. I have reviewed notes 1647267.

I am getting the same errors. I would most appreciate any further suggestions.

Thanks

Tariq

[tanmeya_mohan · Accepted solution]

Hi Tariq,

Can you please check & share the status of "Step 6. Enter Landscape Parameters" in Managed System configuration for system SPP.

Also please specify ST level of your Solution Manager.

Best Regards,

Tanmeya

[former_member190691 · Accepted solution]

Hi Tariq,

Fills all the relevant information for this technical system in LMDB, then check again.

Regards.

Fernando.

[Former Member · Accepted solution]

SOLMAN 702 (12)

[tanmeya_mohan · Accepted solution]

Hi Tariq,

Can you uncheck "check existence of path when saving" as per above screen-shot?

Click save, and continue in Edit mode till the step you receive error.

Then retry to check if error exists.

Best Regards,

Tanmeya

[Former Member · Accepted solution]

😞 Same result

[tanmeya_mohan · Accepted solution]

I didn't get your patch level for ST component?

[Former Member · Accepted solution]

ST-PI 2008_1_700 SP Level 8

ST 710 SP Level 8

[Former Member · Accepted solution]

Hi Tariq,

Update the latest CIM data and CR content in the SLD and re-synchronize the details to SLD and check it.

or

Re synchronize the LMDB details from SLD using below report in solman system and check it,

SE38-> RLMDB_SYNC_TECHNICAL_SYSTEM

Rg,

Karthik

[VJain]

Hi Tariq,

Please check the guide in note:

1858920 - Diagnostics Agent installation with SWPM

Also, 1769269 - LAPI cache is not up-to-date

Thanks

Vikram

[Former Member]

Hello Vikram,

Thanks for your suggestions, I have also review these notes. Same issue persists.

Any further suggestions?

[VJain]

Hi tariq,

Please check:

1647267 - Solution Manager adaptation to Java UME security

Thanks

Vikram

[Former Member]

Thanks for this I have review this note, however not applicable.