SRM Middleware

[Former Member]

Hello everybody

I am triing to configure the SRM middleware and some problems are occuring

I created the sites in SMOEAC

I checked the tables CRMCONSUM, CRMSUBTAB, CRMRFCPAR, CRMPAROLTP and SMOFPARSFA.

But whem I go to transaction R3AS some errors happen (QUEUE_ALREADY_EXITS:R3AI_DNL_CUST_PROD0*)

Please, someone knows what are missing?

Thanks

Nilson

[Former Member · Accepted solution]

Hi

<u>I am sure there is some problem in the configuration.</u>

___________________________________________

<b>Once the replication parameters are set-up and you triggered the process, you will be able to check queues in SMQ1 and SMQ2 (ECC and SRM). Check RFC queues using transaction SMQ1 and SMQ2. Any other errors noticed in SLG1 and ST22 transactions.</b>

<u>Check in the transaction SMOHQUEUE for any errors / logs. Check your R/3 table CRMCRFCPAR.SRM consumer and queues should use the SRM RFC destination, and CRM one the CRM RFC destination.Also, check the consumer and the RFC destinations.</u>

<u>SMQ2 is an inbound queue. When You are starting replication of Material Master, check outbound queue (SMQ1) on backend system and look for DNL or MATERIAL queue name.</u>

<b>Also Refer to OSS note 720819 / 681516</b>

<u>Also Refer links -</u>

<b>

____________________________________________

<u>Please have a look for step-by-step configuration details.</u>

<b>http://help.sap.com/saphelp_srm50/helpdata/en/55/4af548688211d4977e0004ac962ee6/frameset.htm

http://help.sap.com/saphelp_srm50/helpdata/en/55/4af54b688211d4977e0004ac962ee6/frameset.htm

http://help.sap.com/saphelp_srm50/helpdata/en/05/9b8139437eac2ae10000000a11402f/frameset.htm

http://help.sap.com/saphelp_srm50/helpdata/en/69/025f23394c014dbfa64795a6460360/frameset.htm

http://help.sap.com/saphelp_srm50/helpdata/en/29/d586398dcfd74fe10000000a11402f/frameset.htm

http://help.sap.com/saphelp_srm50/helpdata/en/5e/88ef3bc8821d0de10000000a114084/frameset.htm</b>;

Hope this will help.

Please reward full points, incase it suits your requirements.

Regards

- Atul

[Former Member]

Hi,

You must clear the queue first and then run it again.

To clear the queue go to transaction R3AM1 and cancel all queues with status Runing.

Then go to RFC queue (transaction SMQ1 and SMQ2) on SRM and R/3 servers and delete Middleware entries.

If You do this - run program again

Refer to this blog too: /people/marcin.gajewski/blog/2007/02/05/how-to-replicate-material-master-from-r3-to-srm

Regards,

Marcin

Please reward points for helpful answers