COM ROUTINE ERROR

[Former Member]

Hi Any one can explain the reason for Com Routine Error 40.075.

Description:

Error for COM routine using application program (return code 40.075)

All input time series to which you can distribute are fixed

And Please provide the solution also.

Thanks and Regards,

RAVI SAGAR CHENNU

[Former Member · Accepted solution]

Hello Ravi,

Please see the explanation of COM error code 40075

[Former Member · Accepted solution]

Hi Sap50,

Thanks for your reply.

Actually we are copying approved consesus baseline to Regional Baseline forecast after copying it is automatically fixing the keyfigure and it is particullarly for one product and location.When we are trying to unfix them we are getting this error.

and could you please help me regading the com rouitne error 40075,If you need further information I would provide you.

Thanks in advance for you help and support for further,

Thanks and Regards,

RAVI SAGAR

[former_member616050]

Procedure
Remove at least one of the fixings of the aggregated time series
objects.
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
You have fixed information in your planning area, which is causing the
issue to occurs.

So in tscube, if you try and load data into a key figure which has
at least one value fixed, the load will fail, if your selection criteria
in tscube overlaps with the aggregate level of the fixing. The reason is
because, tscube does the data set in one shot for the selection criteria

If your cube is a backup cube and you already have the fixing
information in it, you can use macro to unfix the fixing information in
the planning area, then use tscube to load.
Before executing the TSCUBE,you can schedule this macro job and then
execute the TSCUBE.while defining the macro you can check whether
the keyfigure value is fixed or not using the macro function
IS_FIXED(). If it's fixed then please unfix the cell.

You have fixed information in your planning area, which is causing the
issue to occurs.

To run the macro considering fixings, please, update your macro. Change
the Row properties and flag the "Adjust Fixings" information for each
row.

Also please find the below notes related to fixings:

1599645
687074 Macros: General notes on fixing with macros
643517 Macrobuilder: Fixing key figures with a macro
Even that these notes do not apply because of the SP, information is
relevant.

Also, please, take a look at the online documentation:
http://help.sap.com/saphelp_scm50/helpdata/en/92/cd15426bf3dd2ce10000000
a1550b0/frameset.htm