on 04-12-2014 12:46 AM
Hi ,
We have SLT server with 2 configurations setup (schema) , DEV and QA. on one of these configurations we are using transformation with an include where it is calling a source system via RFC. Normally we would point SLT Dev to ECC dev , SLT QA to ECC QA etc but in this case we wanted to point SLT Dev to another system based on the current configuration ID.
I was trying to get that info from SY table in runtime but couldn't find a way to debug the include.
1. Is there a way to debug include in transformation in runtime ( I tried a hard code break point with no luck).
2. Can I find out using a case statment which configuration is being used ? this will drive the RFC to the correct source system.
Thank you,
Nick
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.