on 04-09-2014 4:27 PM
I am trying to get the max and min value to pull into the QGP1 report for a Quantitative characteristic but so far no luck they are staying blank.You can find them in se16n table QARS or QAMS and the actual field is a structure QGMK MAXWERT. I have tried in results recording to calculate statistical moments to see if this will pull it through but this field is greyed out. Any help would be greatly appreciated thanks.
Hi All
Thanks for your help, but I have figured it out why it was not populating. It only populates if you have more than one result for the characteristic. The characteristic I was looking at only required one result.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
This should show in QGP1 assuming you have your characteristic set up for single values recording. Also, you should be able to see QAMR-MAXWERT in that instance as well. Not sure what those other tables referenced are.
Regards,
JL
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.