on 03-21-2014 6:38 PM
Quick question.
I have 3 SLD's.
SLD A is a central.
SLD B is a local
SLD C is a local
I want SLD A to Bridge Forward to Both SLD B and SLD C. A unidirectional synchronization.
I'm I correct to say to set this up, I need to go into the SLD Administration of SLD B and C, under content synchronization and setup these connection?
Or do i go into SLD A and setup a connection to push to SLD B and C.
I guess the question is where to i make the config? In the Target( SLD B/C) or Source (SLD A)?
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
What systems are these ?
A connection bridge from the Local SLD to the Central SLD should be done from the local SLD system.
Regards
RB
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Joshua
As there is no Visual Admin in NW 7.4 based systems you will need to configure the SLD in the NWA
Check SLD configuration part of this blog for reference.
http://scn.sap.com/docs/DOC-44110
Regards
RB
According to the link SS,
Config is done in the target. So If I want SLD A content forwarded to SLD B, I make my config in SLD B to pull it from A.
OK, sounds right
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
This message was moderated.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.