on 03-12-2014 9:42 PM
Hi,
To debug a Webdynpro component, i try to set an external break point inside my Webdynpro code.
However, the debugger is not called at runtime.
So i goto SE38 or SE37 open any random program or function module and set a external break point.
On doing this, i get a success message saying external debugging has been activated for 2 hours.
Now, i go back to the Webdynpro code and set a new external break point and this time debugger is called and it works.
On some systems, debugging Webdynpro code works directly without the extra step.
This is not a big issue, but i was wondering what's going on here.
Regards,
Jon
Hi,
Check the SAP Notes: 1415154 , 1411633 if you are on relevant Netweaver version.
Else, delete the entries from table ICFATTRIB corresponding to your user ID.
Then, execute SICF, Edit -> Debugging -> Activate debugging.
Hope this helps u,
Regards,
Kiran
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.