cancel
Showing results for 
Search instead for 
Did you mean: 

Data structure does not match

Former Member
0 Kudos

We are at data transfer phase and get an error as follows.

We compare the table between sender and receive side by side , and see NO difference at all.

We believe it's caused by re-defining its migration object during selection.

OSS and SDN do not have similar case.

Thanks for your attention.

Accepted Solutions (0)

Answers (1)

Answers (1)

former_member65049
Active Participant
0 Kudos

Hi,

Data Transfer is in error due to structure mismatch. The reason could be that Structures were changed meanwhile TDMS data transfer was in progress.

In such cases, you should use the troubleshooting activity 'Redefine
Migration Objects ' for the activity 'Data Transfer Start'.

You will find this activity under the node 'Troubleshooting for
Migration Objects '.

When you execute this activity, a selection screen appears where you can
provide the migration objects that went into error in the input box for
'Migration Objects' (e.g. SMW3_BDOC1). Once the input is provided, execute the
troubleshooting activity.

You can check the status of the troubleshooting activity in 'Extended
process monitor'.

Once the troubleshooting activity gets completed successfully,  the status
of the following activities in the process tree gets reset:
1. Data Selection Start for TDMS Header Tables
2. Data Selection Start for All Tables
3. Data Transfer Start

You thus need to re-execute these activities so that Data Selection and
Data Transfer will start for the migration objects that went into
error.

Regards,

Rupam