on 03-05-2014 6:06 AM
Dear All
I had created 1 MIC as Refernce with QN type,sampling procedure is assigned,created sampling procedure with Fixed sample and tolerance check and sample as 5 and free inspection point.This mic is assigned to the inspection plan, but it does allow to assing my sampling procedure.If i use sampling procedure as Fixed sample and manual validation the procedure get assigned but when inpsection lot is generated i cannot enter the value it comes with selection (F4) having value accept/Reject,i want quantitative mic where i can enter the value.
Regards
Check your control characteristics in the MIC. I believe you may need to click on "record measured values". (Or something close to that wording)
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Kunal,
I am not getting your question, but i think your problem is related to valuation mode.
You have to change your valuation mode in sampling procedure to
Attributive inspection based on nonconfirming units
Sandip
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.