Upgrade solution Manager 7.1 SP10 Error PREP_EXTENSION/CONFLICT_CHECK!

[Former Member]

Hi,

I am doing the upgrade activity first time, Installed Solution Manager 7.1 in Maxdb database and started the upgrade using SUM. Extraction road map completed successfully and getting the error in configuration road map.

Error message is        Severe error(s) occured in phase PREP_EXTENSION/CONFLICT_CHECK . Kernel, TP and R3trans were updated. Kindly help me to solve this tissue. Please find the error details below.

This trouble ticket was created by SAPup on 20140204174810

-------------------------------------------------------------

SAPup broke during phase CONFLICT_CHECK in module PREP_EXTENSION / Extension module

Error Message: RFC error system ASO nr 00 function 'SPDA_CONFLICT_CHECK' failed with code 3 key TIME_OUT: Time limit exceeded.

-------------------------------------------------------------

-------------------------------------------------------------

Summary of SAPup:

-------------------------------------------------------------

SAPehpi Release: lmt_004

SAPehpi Version: SAPup release lmt_004 version 53.000

Start Release: 702

Target Release: 702

-------------------------------------------------------------

Summary of host system details:

-------------------------------------------------------------

Regards

Jose H.  

[former_member189797 · Accepted solution]

Hello,

You may first try increasing the system profile parameter

"rdisp/max_wprun_time", after that restart the system to take effect and

try to repeat the phase again, please also review notes # 363000

and # 25528 rdisp parameters / max_wprun_time for your reference.

Please monitor and let us know the result after.

Regards,

Gaurav

[sunny_pahuja2 · Accepted solution]

Hello,

You can activate rdisp/max_wprun_time parameter even without restart but it will be valid till next restart of the system.

Thanks,

Sunny

[Former Member · Accepted solution]

Hi Gaurav,

Thanks for your help. Issue has been resolved.

Regards

Jose

[Matt_Fraser]

Jose,

Have you tried restarting the phase from the point of error?  That might get you past the timeout.  Also, it looks like you might not be using the latest patch level of the SUM tool.  Which version are you using?

Best regards,

Matt