on 01-20-2014 10:15 AM
Dear experts,
We are encountering the below issue in PI:
QoS: Best Effort (Sync)
Sender Adapter: SOAP
Receiver Adapter: SOAP, SSL not used
Frequency: Intermittent, no pattern
The request message is received in the target system but the response message throws the error "can't parse the document; HTTP 200 OK". So, the response message contains only SOAP Header and SOAP Body, but no Payload.
No changes were done to this interface in the recent past. The issue started to occur abruptly.
Error Details:
We extracted the below trace from XPI Inspector:
Looking forward to your replies.
Thanks,
Manoj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manoj,
Issue is with your channel settings. If you are sending a SOAP message to any other SAP PI system, config should be same. I will prefer not to use SOAP Envelope and Header. Uncheck both check marks and try.
Similarly for non SAP system as well. I will use "Donot Use SOAP envelope" only if receiving system is not capable of receiving data in SOAP Envelope. If you are using this check mark, then use &nosoap=true at the end of the URL you are giving.
Regards
Aashish Sinha
Hi Manoj,
Try to test with SOAPui and compare the call with the PI call. That error uses to be an error page or similar in the endpoint the the PI can't parse an answer that is not a SOAP one.
Regards.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manoj,
Did you check if the response message leaves the system correctly before it arrives at PI?
Also the XPI trace is missing. Can you please add it?
BR
Harald
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.