on 01-06-2014 10:32 PM
I need some help in First article inspection it is not working as expected.
The requirement is first time when I create PO and MIGO it should created inspection type 0101 (sample). Second PO onwards it should create type 01.
I setup Status Profile and created Quality Info Record and assigned the Status Profile. I assigned inspection type 0101 and 01.
Supply Profile has Supply relationship Initiated, First Article Inspection & Regular Purchase
When I tested my config for first PO when I MIGO it is creating 0101 type this is what I want..
QIF status before UD is Supply relationship Initiated after UD the status changed to First Article Inspection
For Second PO first partial i get inspection type 01. Second partial it is creating inspection lot 01
For third Partial it is not creating and Inspection lot and the stock is put in unrestricted.
Third or Fourth or any PO i create afterwards and MIGO there is not inspection lot created and the stock is in unrestricted.
Did i do something wrong. I appreciate some help when I create any PO and do partial or full it should create inspection type 01 lot.
Thank You in Advance,
Ashok
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks CSN & Keshav
I tried both and None of them worked.
Case 1:Deselect the inspection type0101 in material master and activate 01 inspection type.
Case2: Created status profile and Assign delivery status for inspection type.
Case 1: MM02 deselect inpsection type 0101
When I deselect the inspection type 0101 nothing happened the stock is in Unrestricted without any lot creation.
Case 2: With Status profile:
Created QIR and assigned the Status profile
Created 1 st PO and Inspection lot created with 0101 GOOD.
QIF status changed from 1st Article Prepration to 1 st Article after UD
Created second PO no lot is created but the stock is put in Unrestricted. I expected to see inspection lot created for type 01 but nothing happened.
The QIF status is 1 st Article it did not go to Normal.
Thanks for looking into my issue and proposing solution. I can try if you further have any solutions.
Thanks in Advance,
Ashok.
I went back to reread this and its been a while. When I reread this, I think I misunderstood your intention.
If you want to generate 01 lots all the time, (i.e. after the 0101 lot), why bother having the first article inspection?
The whole point of 1st article inspection is to NOT generate subsequent inspection lots.
Craig
Hi,
When the desired status is reached we have to deselect the inspection type0101 in material master and activate 01 inspection type.
CSN
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
11 | |
10 | |
6 | |
5 | |
5 | |
5 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.