on 03-15-2007 9:36 AM
Hello Experts,
In my smartform, I have given left margin 1 cm.
Its showing correct output in development but when i m taking output from Quality & production left margin is cming 2 cm,as a result table is shifting out of the page.
Please help me as soon as possible
Thanks.
i think
r u using the same printer or different.
the problem is with the output device. once check outputdevice settings
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
Once goto SPAD check all the parameters of the output device u r using are same in DEv and QAS and PRD.. i don't there is aproblem with u r form design. i believe the problem is with output device or printer...
even somany we face the same kind of problem.
in the output devie>output attributes> there is HORIZANTAL MOVE give 5mm there for the output device you r using. i hope it solve u r probelm.
Please Close this thread.. when u r problem is solved
Reward if Helpful
Regards
Naresh Reddy K
hi
normally the problem will be with the layout desin or output devicesetting.. in u r case u r layout is perfect because it is working fine in DEV.. so it should work in Quality...
as i told if u set the output divice in SPAD -->HORIZANTAL MOVE = 5 MM.. then it should work otherwilse give 1CM.. i have seen this in OSSnote but i didn't remember the number...
wht you cant do now is... in DEV activate the form once again and run it in DEv then <b>retransort the form agin</b>... may be it works...
Please Close this thread.. when u r problem is solved
Reward if Helpful
Regards
Naresh Reddy K
Did you use the same printer types with the same drivers and settings (hardware margin and this kind of things)
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
The possible rasons for u r problem could be...
1. printer is diffent
2. output divice differences
3. properly transported or not..
but in u r case everything is fine as u told.
<b>once try to print someother form in the same printer.. and check whether they r printing correctly or samelike u r form.</b> even in this way if u could not able to find the reason.. cunsult any senior person who knows smartforms very well and those r working in the same project.
i hope u have checked everything in DEV and QAS.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.