IDoc to file Scenario , file not reaching the folder

[Former Member]

Hi All,

My Scenario is IDoc to File. I have maintained the below parameters on both SAP R/3 and

PI Side. I am giving some dummy details. Suppose SAP R3 (SID: SAI, SYSSTEM NO: 00,

CLIENT: 800) and SAP PI (SID: VJY, SYSSTEM NO: 01, CLIENT: 001).  

SAP R3:
---------------

BD54: SAICLNT800, VJYCLNT001
RFC Destination from SAP to PI: VJYCLNT001
PORT: SAPVJY (The RFC destination in this Port is also pointing to VJYCLNT001 ).
PARTNER PROFILE: VJYCLNT001
DISTRIBUTION MODEL is also maitanined from Sender system as SAICLNT800 to VJYCLNT001.

SAP PI:
---------------

BD54: SAICLNT800, VJYCLNT001
RFC Destination from SAP to PI: SAICLNT800 
IDX1: SAPSAI
IDX2: I have imported the IDoc Structure from PORT SAPSAI with clinet 800.

I have tested the IDoc from WE19 and the IDoc got transferred Successfully.

Basi type: ZMATMAS
Receiver:      Sender:

Port: SAPVJY     Port: SAPSAI
Partner No: VJYCLNT001    Partner No: SAICLNT800
Partner type: LS    Partner type: LS

Logical Message Type:

Message Type: MATMAS
Message variant:
Message Function:

Test flag:

I am using it for testing puprose. I am mapping it to only one field on the receiver end and i am also giving the correct values. After trigger i am geting the error as "IDoc was sent to SAP System or External System". But the file is not reaching the ftp folder, i am giving the correct ftp folder and also the message is not visible in SXMB_MONI.

Kindly check and do the needful.

Regards,
GIRIDHAR

[Dimitri]

Hi,

Check transaction SM58 on your sending SAP system.

Kind regards,

Dimitri

[Former Member]

Hi All,

Thanks for the reply. I will check in SM58.

Regards,

GIRIDHAR

[Dimitri]

Just check if the IDOC got stuck there. If yes, try to solve the problem.

If no, check e.g SXMB_MONI on the sending SAP system.

[Former Member]

Hi All,

I have checked in SM58 as suggested in the above replies. I found the below error in SM58.

No RFC authorization for function module IDOC_INBOUND_ASYNCHRONOUS.

RFC Destination is also working fine. But i am using Non-Unicode. My User is RFC_User. If have done the UNICODE Test it is giving "Target is a unicode system (character size 2)".

Kindly suggest me how to proceed further.

Regards,

GIRIDHAR

[Dimitri]

Hi Giridhar,

Check the user you use for executing the RFC.

Perhaps check OSS note 837595 for details about missing authorizations.

Also, message "Target is a unicode system (character size 2)" is not an error. This is just an information message.

Kind regards,

Dimitri

[Former Member]

Hello,

Check SM58 in SAP R3 system.

Thanks

Amit Srivastava