on 11-08-2013 9:43 AM
Hi,
While archiving EDI40 table via SARA using ArchObj IDOC, the scheduled jobs run fine with the created variant for date range selection (Archive and Deletion run fine), but when a dynamic date range is selected for the variant, the jobs simply finish without archiving anything!
Can anyone advice.
Regards,
Naga
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi all,
Thanks for the updates.
Initially i used date range as 'less than current date -30', and it didn't work.
Later used the date range -xxx to -yy, just as in the figure showed above by Jurgen. And i am good to go.
Thanks again,
Naga
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Usually Idoc archiving runs in a cycle with defined period of time. What is the requirement for dynamic date range ?
Regards,
Subhash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Could you pls tell me what is this dynamic date range..? so that i can help.
there are only two date ranges in IDOC archiving
1. created on
2. Last changed on
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.