on 11-07-2013 7:39 AM
Hi there,
Has anyone resolved this?
I have the same error at a client of ours.
Please assist where possible.
Regards,
Calvin van der Walt
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please try and run the step-by-step procedure in solman_setup --> Business Process monitoring tab.
This is the configuration steps to be performed before we start the Business process monitoring activity.
This might help you to identify whether the 'Load Monitor' activity is performed correctly or not.
Best Regards,
Kavita
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Good Afternoon,
I have the exact same issue, what was done to resolve this?
RCTCCTOOL has been run
Latest BPMon notes applied
Read RFC working
Load Monitors performed again
ST-A/PI & ST-PI are on the same level as SolMan
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
have you tried the load monitor object for the same logical component where you tried to create the BPM.
because sometime you done for other logical component. please try again with load monitor,
We faced this issue often, Load monitor object always solves and sync the standard.
Please check.
Thanks
Jansi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sriram M
Which ST-A/PI do you use in Managed system and SolMan ?
Best Regards
Keiji
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sriram
Thank you for the information.
So far I do not see the relevant notes for the issue. And it is first time to hear such a issue.
Normally these issue quickly fixed after load monitor as you did. But if it does not help,
I really wonder what is wrong.
I think this is not relevant, but let me verify.
In both syste, do you already conducted post process of ST-A/PI implementation ?
T-CD SE38 ->RTCCTOOL ->Menu Addon&Upgr =>Procedure after addon imeplementation.
If it is not gree check mark, could you check this and then conduct additional load monitor definition.
Best Regards
Keiji
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.