on 10-30-2013 6:40 AM
Hi,
But the one thing relate to above i/f is, messages are moving to "scheduled state".
see below pic.
except first one, remaining 4 channels were stopped. To be precise the except first one remaining messages should goto error, only few going for error.
This scheduled messages is a big worry for me.
Kindly provide your i/p to clear those scheduled messages.
Avi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Thanks for your time and reply.
I am using ICO. In ICO
"You can remove Maintain order at runtime in interface determination. IMO, serialization should not be required." option not available.
you mentioned 4 channels are stopped...why ?
We want to send all the data only to one interface so .
>> Are you talking about Java nodes.
means? I am not aware of it.
Avi
Hi Avinash,
There could be different target xml structures being mapped in these 5 mappings, JMS queues ca be different. Though this can be achieved through multi mapping, they might be reusing existing mappings for a OM. It might be a direct migration of interface from lower version to PO.
You can come to a conclusion only after going through the mappings and JMS queue names.
Regards,
Pranav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Avinash,
Since you have 5 inbound interface and same receiver, the 5 messages will be delivered to the receiver.
Off course you will need 5 operation mappings.
What exactly you are not clear about.
Ambrish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
ideally if there is no condition message should be sent to all receivers
if the business system used is same and have 5 different receiver channels and are of same type then any failure in one of the receiver will block all other messages ....
if your query is different than this then post exactly what your query is ?
HTH
Rajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Avinash,
I think If you configure with five interface you also need five mappings & if you are not using FCC at receiver side you can use coming CC also &
It will create 5 different message if no condition is there
Regards
gAGan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.