Soap Adapter Post Message

[brian_briones]

Hi gurus,

I have the integration   IDOC-->PI-->URL(POST MESSAGE)

the URL is configured on a SOAP ADAPTER because must receiver the POST MESSAGE.

The monitor say successfully the start to end integration, but the message not reach the destination.

the answer is...

Must I configure some parameter on the SOAP adapter in the advance?

must I use other CC?

plis, help me.

Regards

[brian_briones · Accepted solution]

Was problem of Target. regards

[markangelo_dihiansan]

Hello Brian,

Did you compare the values being expected by the webservice with the values being sent by PI? e.g by using SOAP UI, you could already predict the behavior of the target webservice and then adjust your SOAP Receiver parameters accordingly.

Regards,

Mark

[markus_schalk]

Dear Brain,

it's not totally clear to me what you want to do. Do you want to just post an XML message to an URL?

If yes, did you set "Do Not Use SOAP Envelope" in the receiver SOAP adapter?

Regards,

Markus

[former_member309089]

Hi,

Yes, You need to configure the receiver channel with target URL before testing the scenario .

And pls check the message in Message Display tool to find out if it went through or not .

the URL is http://PIhostname:port:/mdt

[Former Member]

Hi Brian, check in runtime workbench in CC channel audit log is DLVD and payload?

abs