Profile in QP01

[former_member1186946]

Gurus,

I am trying to creating quality plan manually, when i click on Extras at the top,the profile field is in display mode & i am not able to key in the value.How to make it into entry mode?

Screen shot attached

[nitin_jinagal · Accepted solution]

Hi,

First you need to define/ maintain the profile through SPRO settings, Pl follow the below path,

Quality management>> Quality planning>> Inspection planning>> General>> Maintain profile for default values.

Once maintained, you can enter this Profile value at the very bottom of QP01 screen in Additional data.

After this, you would be able to see this value in the Profile field.

Regards,

ntn

[former_member1186946 · Accepted solution]

The value is already maintained.

Once maintained, you can enter this Profile value at the very bottom of QP01 screen in Additional data.--Can you specify where is this additional data in QP01,i am able to see this PROFILE only in EXTRAS tab at the top

[nitin_jinagal · Accepted solution]

Hi,

It is at the bottom of the screen. Pl see the snap shot,

Regards,

ntn

[former_member1186946 · Accepted solution]

I found it ,but still awarding points for the effort

[nitin_jinagal · Accepted solution]

Thank you

Regards,

ntn