Excise Posting - J1IEX

[Former Member]

Dear Experts,

   Excise is applicable for all incoming materials.After doing the GR part I is posted,excise values are captured correctly in MIGO(Updated in table J_1IEXCDTL).

  After posting PartII in J1IEX, values are mismatching in J_1IEXCDTL and J_1IGRXREF table for 1 excise invoice only.

   PO is created with 6% of BED and it is captured correctly in MIGO and PartII is also posted with 6% of BED.

   While doing the invoice, excise values are picking from J_1IGRXREF table (updated with 2% BED with PO value).

   Kindly let me know how the values are updating in J_1IGRXREF table.

Regards,

Narendra

[former_member192897]

Did you change the excise values during Excise posting? If there is no change in Excise in MIGO Excise Posting there should not be any difference in J_1IEXCDTL and J_1IGRXREF tables.

System reads the excise values from J_1IGRXREF table during MIRO... Could you check and share the screen shots of your excise postings..

[Former Member]

Hi

Now for this one document you may correct the values in table J_1IGRXREF based on the

values in table J_1IEXCDTL.

Data MUST match between these two tables, only then the values will flow correctly in MIRO.

Regards,

Rajasree R