B2B Addon : Catching Exception Calling Messaging System

[Former Member]

Hi All,

I am working on B2B integration, PI 7.31.

In the inbound interface, EDI fiel is getting picked up the sender file channel, however the sender and Receiver EDI Separator channels are throwing error ' Cathing exception calling messaging system'.

Please guide how to resolve this, I have refered below thread, but couldnt resolve it.

http://scn.sap.com/thread/3309007

Thanks,

Ruchi

[former_member729713]

Hi Ruchi,

I also had the same error, it was resolved after removing the SWCV name from the 2nd ICO.

But why it is so, is there any specific reason to remove that?

[Dimitri]

Hi Ruchi,

In thread http://scn.sap.com/thread/3419871 , I advised you to upgrade the B2BTOOLKIT component to a higher patch level. Did you do that in the meantime?

Also, you mentioned an adapter service being stopped. Perhaps you need to check your complete PI system. It looks like you face several problems using the B2B add-on, but I guess they are residing on system level and not specifically on the B2B add-on level.

Please do the upgrade and check your system's health.

Kind regards,

Dimitri

PS: there is a community, dedicated to B2B integration with SAP PI/PO, where you can post these kind of questions. Feel free to take a look at http://scn.sap.com/community/b2b-integration/content

[Former Member]

Hi,

The issue is resolved by removing the SWCV name from the 2nd ICO, inbound processing.

Thanks,

Ruchi