on 03-12-2007 3:51 AM
In the minisap setup process, when I use the recommended loopback setting and change the ip to 10.10.0.10 and also change the host file.
But If I do this , it's really slow for my minisap to run~~~
So I just change the ip to local host (127.0.0.1)again, then the minisap run much faster?
Would anyone give me some sugestions about how this happened?
Hi,
Check below links for information:
<a href="http://www.microsoft.com/technet/prodtechnol/virtualserver/2005/proddocs/vs_operate_using_loopback.mspx?mfr=true">http://www.microsoft.com/technet/prodtechnol/virtualserver/2005/proddocs/vs_operate_using_loopback.mspx?mfr=true</a>
<a href="http://www.kbalertz.com/Feedback.aspx?kbNumber=236869">http://www.kbalertz.com/Feedback.aspx?kbNumber=236869</a>
Regards,
Subhasha Ranjan
Reward points if helpful.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Subhasha:
I found the related information in the first link you give.
(You can use any Transmission Control Protocol/Internet Protocol (TCP/IP) address, but it is best to choose one from a reserved range of non-routable TCP/IP addresses. For example, TCP/IP addresses of the form 192.168.x.y, where x is a value from 0 through 255 and y is a value from 1 through 254, are non-routable.)
Great thx for your information!
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.