RBA - Bypassing the input location

[marcelo_kayroquintaofigue]

Hello.

I have five location, 10 - 20 - 30 - 40 - 50.

In specific situation(shipping conditions) i want only produce in 50.

In this case, i created a substitutions list with these values

from 10 to 50

from 20 to 50

from 30 to 50

from 40 to 50

In Rules Control i set:

Location: Work Foward from input, cyclic  - 2nd Access(Checked)

Qualified Location: Start(First location of Subs. List).

If a run ATP with these configs, for location 10. The result will be product X and location 10.  But i need location 50.

My question is, how to bypass the input location? how to select the first substitution location, even if i had free capacity in input location.

Best Regards.

Marcelo

[Former Member]

Hi Marcelo,

         As Michael mentioned already,in the check instructions, if you activate the setting "Rules Immediately" in addition to the already existing setting "Activate RBA", the system will check for the first substitution location and ignores the input location even it has sufficient quantity/capacity.

Thanks & Regards,

Srikanth.

[michael_thinschmidt]

Hi Marcelo,

Did you activate "rules immediately" in the check instructions ?

best regards,

Michael

[Former Member]

Hi Marcelo,

  In the rule control try setting up "Start from bottom of the list" , in your case though you have stock at location 10 , the order will get confirmation from Location 50 .

Hope this helps.

Rgds,

Kiru