on 03-09-2007 5:58 AM
while creation of new material the system throws up a message
Unit of measure 019 is not defined as a commercial unit
I have mentioned the unit of measure as EA for my material.
Please advise
Thanks
Adi
HI
Go to T.code. CUNI. and check whether EA is iso code. and
in Commercial change it as OFF. it will work now. Just now
i have saved my material. After changing Commercial to OFF.
reward if it is useful
regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Aditya,
Chcek the UOM Settings for the particular UOM you are using in Tcode CUNI
Or
SPRO-F5-General Settings- Curriencies - Check Uint of Measurement.
REWARD IF IT HELPS
regards
Srini
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Aditya,
If it is correctly assigned in CUNI then this error should not appear. chcek once again in CUNI.
ELSE
In mm02 go to additional data and check the UOM Group assigned you can chcek these settings in spro-f5-Logistic general-Material master-settings for key fields-define UOM Groups
also check if any probelm with conversion / proportion/production unit etc.
REWARD IF IT HELPS
regards
Srini
Hi
Please check whether EA ( each) is there in the Match code or not..
Regards
MBS
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.