HU/WM Pick HU

[Former Member]

Hi All,

I have got WM-PP Interface and create a process order with direct TO creation. For the confirmation of my TO I would need a Destination HU (Pick HU). Is it necessary to work with a Pick-HU or can I only use the same source HU when I excactly need the qty of the source HU?

I ask myself, why should I print out a new HU - Label, when I transfer a entire HU to my destination. So I don't wanna get a new HU number.

Thanks.

Regards

Daniel

[Former Member · Accepted solution]

Yes, You can use the source HU as the destination HU. Source HU can be defaulted to destination HU through Warehouse Management Mvt Type config.

[Former Member]

Hi George, Hi Samir,

thanks for your responds.

I found the place where I can maintain the pick-hu control.

Regards Danny

[samir_suryawanshi]

Hi Danny,

Pick HU is required only when you break the pallet i.e partial picking.In this case original HU number stays back in the source bin. In your case you can use the source HU as destination HU as you are picking the entire qty.

rgds,

Samir