on 08-14-2013 10:49 AM
Hi guys,
Is it possible to install Net weaver 7.0 or above in Non Unicode??
Thanks
CD
Hi Chrs,
Technically speaking ..You can install a Nw7.0 system as Non Unicode. But SAP recommends converting it to Unicode. But Non Unicode systems are still support when you perform the system copy of an SAP system upgraded to SAP NetWeaver 7.0 SR3. This might be the reason why SAP still retains the option for “Unicode system” selection box in the installer.
Anyway as said by Hannes and Rishi, its will be better to convert your system to Unicode ASAP for the better support from SAP.
Regards
Sandy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Chris,
This note describes clearly: 1896539 - Questions about compatibility and end of support to non-Unicode systems
All new systems have to be installed as Unicode systems.
Regards,
Serhat
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Derik,
going forward there is an end for non-Unicode support in new releases: "SAP NetWeaver 7.40 is the last release supporting non-Unicode" (check at https://service.sap.com/~sapidb/012002523100009958832014E/ or see SAP Note 2033243).
Best regards,
Christian
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Chris,
it is possible, but not recommended or supported (depends on your requirements). See SAP Note http://service.sap.com/sap/support/notes/73606
e.g.
"2. As of release SAP NetWeaver 7.0 Unicode is the default for all new installations of Single Code Page systems
3. Unicode is the mandatory system type: ...."
If your requirements fall under point 3, then you need to go ahead with Unicode.
Regards,
Hannes
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please check the below note .
Note 838402 - Problems within non-Unicode system landscapes
New releases of SAP NetWeaver and SAP applications based on SAP
NetWeaver, released in 2007 or later, will no longer support new installations of non-Unicode systems. See also the attached customer letter Customer_Letter_64_U.pdf from April 11th 2006 (also available at www.service.sap.com/platforms).
Existing non-Unicode systems are still supported, but due to the intrinsic limitations of non-Unicode code pages SAP recommends a conversion to Unicode, especially when upgrading system to Netweaver 7.0 (ERP 2005) and higher releases.
Problems can occur after any upgrade, even whithout applying new applications, e.g. in case.existing applications are redesigned based on new technologies.
Please also check the below link.
http://scn.sap.com/docs/DOC-28791
Thanks
Rishi abrol
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.