cancel
Showing results for 
Search instead for 
Did you mean: 

ECatt error when activating Best Practices ERPV606 AU Activation

Former Member
0 Kudos

Hi,

While activating a standard Best Practices Solution I am getting an ECatt error where Exported parameters are not being seen as declared.

Being new to Best practices and ECatt I have followed the quick guide 'BL_ERP606_Quick_Guide_EN_AU'

A summary,

Standard SAP install SAP ERP 6 EHP6

Add Best practice Add Ons

               BP-ERP 606V6 & BP-SOLBLDV9

Checked Business Function Sets

Created a client (copy of 000), set to customising

Applied Notes related to BP-ERP606V6 and BP-SOLBLDV9 (including transports in BP-ERP_606V6_Corrections.zip)

Pre activation activities, generation of reports etc

Set sapgui/user_scripting with RZ11

Set Allow scripting on local GUI

Upload solution file - BL_ERP606_AUV1.xml

Upload installation data - INST_FILES_AU_BP_ERP606V6.zip

At this point I get some ecatt errors specific to some

I thine try activating the whole solution and get the following errors:

(Image1.png)

When opening up the ECatt I have the following when executing the Test Script:

Image2.png

The error message is:Parser: 'CHECK_FASTSTART_1-EXPORTING-E_FASTSTART' is not declared

however the issue is that none of the export parameters from test scripts are being seen as 'declared'.

This error just refers to the first instance of an export parameter being referenced.

When running the Ecatt Check fast start it runs successfully.

When running the ECatt /SMB99/PREREQ_INTEGRATION_100 it fails with the same 'not declared' error.

I have searched for notes, scn forums and ecatt documentation.

I am running with SAP_ALL authorisations and there are no other errors seen across the system.

thanks for any assistance.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Which SPS do you have? You should activate baseline with SPS03

Former Member
0 Kudos

Hi Juan,

thanks for replying.

I am at support stack 7,

Former Member
0 Kudos

Thanks Juan for asking that question,

I have reread the section at the start of the guide:

If you run the activation on a higher SPS you may run into activation
errors. If you encounter this, perform the activation activities by switching
the eCATT to run in foreground mode or implement the configuration manually by
using the configuration guides. For more details refer to the document SAP Best Practices Tools that is
provided on the documentation DVD in the section Technical information area Tools
and Concept.

If you need a higher SPS level in your system FIRST
import and activate SAP Best Practices on the SPS levels as mentioned below,
THEN upgrade your system to the current SPS level.

I have read up on the Tools documentation and run the ECatt in the foreground however there is no change to the error:

I will start rebuilding a system at SP3 while trying a few more things with the current system.

thanks

Former Member
0 Kudos

please implement note 1869878 this should help

mark my answer as usefule if it worked

Former Member
0 Kudos

Thanks Juan,

That was it,

I needed to search notes for ecatt and sp7.

Gordon

Answers (1)

Answers (1)

Former Member
0 Kudos

Hello,

could you please follow installation docu .Bcoz all steps and troubleshooting in doc.

Warm Regards,

Prabharan B