cancel
Showing results for 
Search instead for 
Did you mean: 

Idoc Replication in Target system through PI

Former Member
0 Kudos

Hi,

When we send an IDoc from SAP Quality System to Client  3rd party system they receive only 1 message (IDoc)and repetition is not done here.

When we run the same scenario in Production system replication happening in 1:4 ratio (One sender SAP Idoc  replicate to 4 Idocs(Duplicates) in 3rd party system but PI have one message).

Scenario moves like:

Outbound Process is  :

** SAPSYSTEM- ----------> PI – ---- --->-Third Party Middleware(BIZTALK LBI) --------->Client SAP ECC system.

Note:

1) We have done all connection checks from SAP to PI and 3rd party system.\

2) It was happened only Production System, but working fine in Quality system with same settings.

Please guide me on this.

Regards,

Sankar

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

Hi All,

We have tested all configuration objects and settings in PI system seems ok, also  we tested fire wall hits  we are getting loved results , but after delivered   to 3rd party system the message ratio is differ.So please suggest..

Thanks

Sankar

ambrish_mishra
Active Contributor
0 Kudos

hi Sankar,

Simply pick an IDoc in ECC in prod and check what PI generated at BizLink side. How are you communicating with BizLink ?

I don't think you alone should be worried about the message ratio since another message broker is involved here.

Ambrish

Former Member
0 Kudos

Hi,

Ask the BizTalk Team to test the messages sent by PI...for the idoc ratio...

There might be some thing wrong at the client side ..biztalk...

HTH

Rajesh

Former Member
0 Kudos

Hi All,

Our Network Team identified messages hitting in our firewall  with ratio 1:4

Please guide

Thanks,

Sankar

Former Member
0 Kudos

Hi Team,

Please upadate

Thanks,

Sankar

ambrish_mishra
Active Contributor
0 Kudos

Sankar,

All you can do is check your Operation mapping and configuration and share the RWB payload if PI is not the culprit. Might be that BizLink is doing something here.

Ambrish

rajasekhar_reddy14
Active Contributor
0 Kudos

1)Check how many IDocs were generated in ECC Production box,if it had generated only one IDoc then problem at PI end.

2)Take payload of IDoc message and execute PI Message/Operation mapping,check output of mapping,if mapping output is one IDoc then check Communication channel monmitoring and audit log.

3)If mapping generated multiple IDocs then compare QA Box development with Production and make sure that both the environments are in sync.

4)Check with Biz talk team how many messages were received and time stamp,based on that you could do more investigation.

nabendu_sen
Active Contributor
0 Kudos

Hi Sankar,

If PI QA and Prod configurations are in sync, then the logic / configuration for IDoc replication must be residing at the 3rd Party side. You can not control that.

Regards,

Nabendu.