on 07-24-2013 12:06 PM
Hello,
in my scenario, I want to receive and initiate a file (e.g. from a file sender channel) on PI, and depending on the content, I want to stop the file without errors. I used to do this in the receiver agreement with the "when no recever is found, ignore message" before PI 7.31 and integrated configuration.
I can do this in the integrated configuration also ("ignore"), but then the message does not show up at all in the message monitor (if there was no error at initiating the message). In the channel monitor, I see a message ID, but clicking this message ID will not get any result.
Any idea?
Thanks,
Christoph
Hi Chris,
did you check in the message in below path?
Configuration and monitoring home-->Monitoring-->Adapter Engine-->Message monitor
you could also try message logging with the help of below blogs.
Hope it helps..
Regards,
Muniyappan.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
With increased log and staging settings in the Integrated configuration, it worked.
Thanks @all.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
did you try to assign a routing rule? in case the content wasnt as spectec the message will appear in the monitor with red flag.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
24 | |
11 | |
9 | |
7 | |
6 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.