Deletion of MIC

[vivek_varun2]

Hi all,

Can any body tell me how to delete MICs from system . The one which is not used for inspection plan that I have deleted through qs25 but there are many  which have been used in inspection plan but we need to delete it.

Kindly assist me.

Thanks & Regards

Vivek Varun

[former_member42743 · Accepted solution]

You can usually only delete the MIC's once you have archived off all the inspection plans that use them.  And to do that, you need to archive off all the inspection lots that use those plans.

If you don't want a MIC to be used, it's usually easier to just block it using the status field.

FF

[Former Member]

You cannot delete a master inspection characteristic , if the characteristic is used by an inspection plan or a material specification (if this is so, the usage indicator will be set). In this case you must first eliminate all uses of the master inspection characteristic by deleting it from the inspection plans and then set the master inspection characteristic status to 4 (set for deletion).