Client copy issue

[former_member211991]

We are facing problem after client copy from PRD to QAS.  Standard reports like FBL1N,FBL3N,FBL5N are not showing the data. Please help me to sort out this issue , Herewith I attached the log of copy.

[Nibu]

Hi

Was it an export/import copy ? If so , did you perform SCC7 , post client copy procedure ? What was the result of that post client copy procedure ? You are supposed to run and complete the post client copy procedure too .

What status it shows in SCC3? is it completed successfully ?

[former_member211991]

it was remote client copy through scc9. 

SCC3 shows completed successfully.

[Nibu]

OK,, have you excluded any tables while scheduling Remote Copy ?

Just check the details, if you have excluded , such issues may happen . And still you can transport these tables from the source system . Just try to copy via Db level and even you can do it application level too .

[Former Member]

Please check the file logs/import logs from SCC3 for more information on this issue.

[mstitsel]

Hi Muhammad,

You performed a client copy from one system to another.

Depending on what profile you used, content is transferred.

If you use customizing, then only client dependent customizing is copied.

You are talking about reports that are missing.

Reports are client independent.

Regards, Marco

[Former Member]

Hi ,

Can you please update what was the profile that was copied.

Thanks

Rishi Abrol

[former_member211991]

The profile was SAP_ALL

[Former Member]

Hi,

If the profile SAP_all was copied then this should not be an issue.

Can you please check with functional team if some config changes need to be done.

As you have done SAP all copy you might have to do some post client copy steps like.

Check the logical system name in BD54.

Check the SP12

Check and change the WE20, WE21 if required.

Run secstore check that all the RFC are working fine .

Check the timezone settings

Check Inbound and OutBound Queues (SMQR and SMQS).

Check the STRUSTSSO2 connection

Delete the CUA Setting in WE20

Check BD64.

Check SCOT settings.

Configure the Workflow.

Identity Management Configuration.

Restore the ECC source system in the BW.

Thanks

Rishi Abrol