LT06 after 315 MM mvt

[former_member637207]

Hi,

I am trying to make a 2-step transfer between two storage locations within the same Plant.

Storage location A (non WM managed) to storage location B (WM managed)

I've done the required config in OMLR to pop up LT06 after mvmt

***

315

312

X

X

DIG

Which means that after 313 mvt that issues the material from storage location A, I'll make mvt 315 to receive the material in storage location B. After 315 mvt it should pop up LT06 to create transfer order, but it doesn't, it just creates the transfer requirement.

Can anybody help on this?

Thanks in advance

[JL23 · Accepted solution]

OMLR has the WM reference movement type  (315) and the WM movement type (312)

if SAP does not do what is customized here, then I would say it just had not read this customizing.

Go into IMG > LE > WM > Interfaces > Inventory management > define movement types

And check which WM movement type reference is assigned to your 315 IM movement type.

In my system IM 315 is assigned to WM ref 312

If that is the case in your system too, then you made the setting at the wrong movement in OMLR

[JL23]

Is this ***  your warehouse number, or do you find another entry with your real warehouse number that my be setup differently?

[former_member637207]

My warehouse has another number, but all my entries in OMLR are set for all warehouse numbers (***).

The warehouse number is not set diferently.