Need help in Muti Message interface.

[Former Member]

Hello Experts,

one sender and two receivers with out using BPM is the interface i have developed.

in mapping based in condition spiting the messages to particular target.

in this interface two targets are SRM and ECC systems.

so now in receiver determination how to create it, do i need to add two targets receivers?

if yes then i can see two inbound messages for each target systems?

kindly help in this.

Regards,

chinna

[ambrish_mishra]

Hi,

Are you using Dynamic receiver functionality in PI to determine the receivers or in receiver determination step from the payload ?

If it is the later, You can have 2 inbound interfaces,2 operation mappings and add 2 receivers in receiver determination. This is much simpler.

Hope it helps!

Ambrish

[rajasekhar_reddy14]

Yes , you have to add two receiver systems under receiver determination.I would prefer two different mappings and create a condition in Receiver determination.

[Muniyappan]

Hi Chinna,

in this interface two targets are SRM and ECC systems.
so now in receiver determination how to create it, do i need to add two targets receivers?

yes. you have to add two target receivers.

if yes then i can see two inbound messages for each target systems?

in sxmb_moni you can see one sender and two receiver message.

Regards,

Muniyappan.