GRC AC10 BRM - Invalid Tcodes

[former_member1044131]

Hi Gurus

Please help, I am receiving an error on BRM when Generating some roles. The error I am receiving is "Invalid Tcodes" pointing to my logical systems, this error is not happening with all roles but a few roles so far.

Your help is highly needed in this matter

Regards

G.M

[Former Member · Accepted solution]

Hi Lentobo,

The error "Invalid Tcode" or "Illegal Tcode" happens normally
whenever you import roles from one system and trying to generate
the same role in other system, and if there are some Tcodes which are
not available in that target system, GRC gives this error message.

So you need to find out which all Tcodes are not available on your
target system. Also, try to use those systems, which can be synchronized
with each other, in one landscape. If your systems used under
one landscape are not synchronized with each other, you may face this
problem.

Please check the below SAP Notes-

1066687
1441463

If applicable to you, kindly apply the Note in the plug-in system.

The note 1066687 needs to also be in your plug in system which you
tried to generate the roles. Kinldy also check to make sure the plug
in also has this same basis leve as this note

Best Regards,

Nandita

[former_member1044131 · Accepted solution]

Thanks All for the great input,

I checked all Tcodes in the Roles which gave error Invalid Tcodes and only to find that indeed there where Tcodes which did not exist in the Target system hence I was receiving the Error. After synchronizing the systems the Error is now resolved,

Once again thanks for the valued help

Regards

George Mothupi

[Former Member]

Hi G.M,

You also need to implement 905646, 1236420 and 1409984 as a pre-requisite of 1066687. Please ensure the RFC authorizations for this connector has access as required in the security guide. You may also use the following notes to check and ensure all integration scenarios assigned to the connector:-

> 1637530

> 1562760

BR,

Yukti Sharma