Issue in LSMW in mass deletion of condition records

[Former Member]

Hi all,

While deleting condition record using lsmw i am facing one issue.

While reading records from file SEL_DETE field came as only one charecter.

So i am unable to delete the records.

Please suggest.

Regards'

Kumar

[JL23 · Accepted solution]

a known problem, as you can read in a few older discussions when you search with SEL_DATE LSMW

this one has a solution, I never tried it, because I use standard batch input or IDOC method for conditions: http://scn.sap.com/thread/1251338

[Former Member · Accepted solution]

thanks Jürgen L.

Resolved issue.

Regards'

Kumar

[former_member186385]

Hi Mukul,

Generally Deletion indicator field will contain only one character which is X

do you see something else other than X ?

regards,

santosh

[Former Member]

Hello Vemuri,

Not very accurate but you can try with following optio

Pls Check the Table status. Some tables are in the Partially active Mode Because If a changed object is activated, all the objects depending on this object must be adjusted to the change.

The active versions of the dependent objects are activated again. If errors occur when adjusting a dependent object, it is marked as partially active (since the object is no longer correct). The activated object itself is also marked as partially active (since the dependent object could not be fully adjusted to the change.

Check the below tables..

VAKE-DATAB = SEL_DATE.

  SEL_DATE

  T185F

Regards

Amrit.

[siva_vasireddy2]

Hi,

Confirm whether you are using recording method in lsmw to do this transaction.

[Former Member]

Hi,

Yes I using recording method in lsmw to delete condition records.

Regards

Kumar