on 04-29-2013 8:55 PM
Hi All,
After I do GR, inspection lot is generated. Now I intend to move part of the qt to 917 and rest to final destination bin. I understand while i create a TO w.r.t the material document, system should show a pup up message where I should enter the sample qt which should go to 917,st type and rest should go to final st type. But this pup up message does not appear while creating TO and all the qt going to final destination st type only.
To my understanding I have configured all settings for QM-WM interface but not sure if I am missing anything else. pls help!!
Regards,
Anub
Hi,
If the usage decision is made for the inspection lot, then you will not get the pop-up message to enter the sample data, please check the below link.
http://help.sap.com/saphelp_45b/helpdata/en/c6/f842934afa11d182b90000e829fbfe/content.htm
Regards
Vijay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
11 | |
10 | |
6 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.