on 04-24-2013 8:34 PM
We are recording value using QA32/ QE51N/ QE11. After going in screen we record result and click on enter where system does auto valuation of recorded result & close MIC. If we select MIC and directly try to valuate it then get message saying "Characteristic/Sample must be processed before it can be valuated", but this we can ignore and continue our activity. This part is fine. No issue here.
We are recording multiple sample for each inspection lot. So it is pain for business to go in QE51N/ QE11 and select sample one by one to record result. So we are planning to create some custome transaction copying QE11..Where business can scan sample, which call QE11 screen for recording. To achieve above req I'm doing recording of QE11 using SHDB...Now when I'm calling QE11 from SHDB and click on valuate MIC before recording then I get same above message of "Error in valuation", and it stuck there. It is not going anywhere & system does not allow to ignore. Only option to log-out from the system, which is not acceptable.
Have any one come up with this scenario issue or solution?
When we were executing SHDB system was not ending recording session that was the issue in this case.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks Vivek for reply. In our system valuation mode is 700 - Mean value within tolerance range.
Just again wanted to inform you that if you use QA32/ QE51N then no problem, but we have requirement to design custom transaction to call this. So for that I'm doing recording at SHDB and the said pop-up is not going even after clicking of 'X' button.
Dear Eric
I changed the sampling procedure to 700 (Mean Value within tolerance range)
I went to SHDB transaction --> QE11 transaction --> Specified inspection lot --> Put in Physical Sample --> Entered result for MIC --> Clicked "Valuate"
Please check attachment
You might be facing issue at the point of entry of inspection lot or physical sample. Check your authorizations via /nSU53
Regards
Vivek Tembe
User | Count |
---|---|
91 | |
10 | |
10 | |
6 | |
5 | |
5 | |
5 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.