cancel
Showing results for 
Search instead for 
Did you mean: 

User status

virendra_pal
Active Contributor
0 Kudos

Hi

I have set the user status as shown

10 ZCTD CRTD - PO/PR not all 10 20 1 1

20 ZREL REL - No Activity Al 20 50 1 1

ZCTD - does not allow PO or PR

ZREL is set on REL and does not allow activity allocation

The problem is that I can set ZREL manually by going into the WBS detail although I have not set REL. I have tried all combinations of the lowest and highest number. Any ideas??

Regards

Virendra

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi all,

I have also tried some test but could not achieve it.

Have you considered the use of a validation at the time of saving? That might

be better that modifying the screen...

Regards

Martina

former_member186143
Active Contributor
0 Kudos

so you want to forbid that someone can change is manually ? but it may only be changed by the system ?

virendra_pal
Active Contributor
0 Kudos

correct - I want ZREL to be set only when sys status REL set.

former_member186143
Active Contributor
0 Kudos

I believe you can authorize on user status in you're authorisation rolles. I don't know the exact name of the object for this.

so the system can set the status but a user cannot

virendra_pal
Active Contributor
0 Kudos

Hi

Thanks for your answer. I am considering that option and your input is helpful, But I was more interested to know if there is any way I can do this without use of authorisations. If there is no way then I will apply the auth method

Regards

Virendra

former_member186143
Active Contributor
0 Kudos

ok after the weekend I will check it out further if I can think of a way.

former_member201206
Active Contributor
0 Kudos

Hi A. de Smidt,

Would you please post the result here, if you find the solution.

I have done some tests without success.

Thanks and regards,

Zhenbo

former_member186143
Active Contributor
0 Kudos

nop , I thought perhaps that you could try with authorisation object B_USERSTAT

but I can't see how.

perhaps modify the buttons to set the status from the screen itself if it's really necessary. perhaps also wise to set the recording of status changes so that you can always find out afterwards if someone set the status manually.