Catalog 3 usage decision

[Former Member]

Hi All,

Simple question.

I created a new catalog (QS41) and after that the correspondant set in (QS51), to assing it to my plant AAAA.

But when i do the usage decision QA11 is still listing the standard set corresponding to plant 0001.

What else do I need to set ?

Thanks !!

[former_member620323 · Accepted solution]

Hi,

If you want the UD code that you made, so that you need to maintained in below path-

Tcode QCC3 -> Inspection Lot Creation -> Maintain Inspection Types -> Select Inspection type that you are inspecting -> click on details  & maintained the UD selected set field & tick on Selected set in same plant.

After this setting, check the UD code for that inspection type.

Hope this will helps you....

[Former Member · Accepted solution]

Worked if you marked the other ones as "no used"

[Former Member · Accepted solution]

Dear Diego Rivera,

The reply given by Rahul is correct, you can close the thread now.

Regards

Neelima

[former_member42743 · Accepted solution]

Read the previous post carefully.  You probably didn't check off the setting "Selected set in own plant"

FF