we are getting the error as "no measurement unit assigned to ISO-Code space"

[Former Member]

We are getting an error for some of the IDOC posting as "

No measurement unit is assigned to ISO-Code SPACE", however we have maintained all the ISO codes under cuni.

please respond on what causing this issue, because this error is happening for only one of the IDOC's, How to debug it

[JL23]

This message is issued if your IDOC does not have an iso code at all.

see the coding in function module UNIT_OF_MEASURE_ISO_TO_SAP

[Former Member]

I checked in CUNI n looks ok, my billing IDOC is failing only for specific site with GEWEI = KGM and for the rest of the sites its posting without any error.

[Former Member]

Hi Experts,

Please respond on this issue, your reply would be much appreciated

regards

Krishna

[JL23]

It is hard to answer as no information is given.

You have not mentioned which IDOC you are using

you just said " CUNI n looks ok" , how shall I verify that

there is no screen shot for both

I have no information whether you or an ABAPer has debugged the function module that I mentioned.

And there is no explanation for this statement: specific site with GEWEI = KGM

Why is this special?

[Former Member]

This Issue is resolved, this error is coming because the rounding profile is not attached under article master purchasing view, after attaching rounding profile this problem has got vanished.

[former_member186385]

Hi,

In CUNI check what is the ISO code Maintained for your UoM

in general all the IDOCs will take ISO code as UoM and it should have corresponding ISO code assigned for UoM

so check it is CUNI

revert if you need more details

regards,

santosh

[Former Member]

I checked in CUNI n looks ok, my billing IDOC is failing only for specific site with GEWEI = KGM and for the rest of the sites its posting without any error.

[Former Member]

awaiting for your reply.

Thanx

KrishnaSAP