Print movement type 553 and 321

[Former Member]

How Can i Print movement type 553 and 321

Thanks in advance

[Former Member · Accepted solution]

What do you want to print in those movement types??

Get the corresponding material documents from MSEG table & print the required details.

[Former Member · Accepted solution]

I would like to print the material document that is displayed in
t code migo but using movement type 553 and 321.

Can it be printed with the same way as the other movement types I
just click on print via output control flag and either it print immediately or I
go to mb90 and I can print it from there

I did all the settings in spro but it doesn’t work for movement
type 553 and 321

Thanks in advance

[Former Member · Accepted solution]

1. Maintain the Printer Name in SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Gen Settings->Printer Setting

2. Ensure that in SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Gen Settings->Item Print Indicator, 1 stands for Matl Doc print out

3. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Gen Settings->Print Version, maintain Print Version 2

4. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Print Control->Maintain Print Indicator for GI/Transfer Posting Documents

5. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Output Determination->Maintain Output Types, for the Output types WA01,WA02,WA03,WE01, WE02 and WE03, ensure the foll:

a. Default Values: Dispatch Time is 3 or 4 as per reqmt. and Tr medium is 1

b. Print Parameter is 7

6. In SPRO->Matl Mgmt->Inv Mgmt and Phy Inv->Output Determination->Printer Det->Pr Det by Pl/StoLoc, maintain the Output device for all your Plants

7. Go to MN21, for Tr Type WE, Print Version 3, maintain Print Item as 1.

Now the settings are ready for Printing Material doc

8. While doing MIGO, ensure that in General Tab, you get "3 Collective Slip" beside the Print Indicator and you tick mark the field.

9. Now depending on the setting in 5a, the Matl doc is printed. If it is 3, you have to print it using MB90. If it is 4, it is printed immediately

Check the settings in MN21 & MN22.

[Former Member · Accepted solution]

Thank you for your reply but I did all of these steps before and
it works with most of the movement’s types but it doesn’t work with these two movement
types

It doesn’t allow you in migo to check the output control flag even
if I have already created an output type

[Former Member · Accepted solution]

In order to print movement type 321 and 553

After you do all the steps above you need to go to T-code mn21
and enter output type WA03 for collective slip then inside the transaction
under field (trans./event type) rather than entering WA you need to enter WQ
and then follow normally the steps above.