Error while Creating CHarm Project

[Former Member]

Hi Guys,

I am configuring CHARM Sol 7.1 SP07.

TMS landscape is as follows

DEV130-->QAS200-->PRD300

I have created the project in SOLAR_PROJECT_ADMIN and assigned the  logical components.

While performing the CHECK under Change Management tab.

Its displaying error "Project Charm_TEST is not found in the project administration table.

I check the table  /TMWFLOW/PROJMAP and i can see the enteries in the table.

Please advice how to proceed

Regards

Abhishek

[Former Member]

Hi abhishek,

I'm not sure if this will work, but I resolved the similar issue performing the following steps:

1. Look at table /TMWFLOW/PROJMAP , your projects could be locked somehow.

2. Select your project in this table and Press ‘Change Icon’

3. Change the status of your project from ‘Locked‘ to ‘Active‘

4. Save it.

5. Go back to your project and activate CHARM straight away (without performing the new checks, do not press the ‘Check’ Tab !)

6. CHARM should be active now

7. Check your project (press ‘Check’ Tab).

8.  All checks should be green now.

9. Go back and activate the Task List for your project.

Let me know if this helps.

Cheers,

MM

[Former Member]

You need to assign logical component to the project.

[Former Member]

Logical Components are assigned

[Former Member]

Hi Abhishek,

IS the IMG project /CTS project created in your dev system?

Logon to Dev System and see in tcode SPRO_ADMIN if the charm_test project is there.

Click on IMG  Projects in the above screen and see if it shows green?

Thanks,

Jagadish.

[Former Member]

Yes, it was there.

What i did was activated the Change Request and Checked again. Then it displayed Green.

Regards

Abhishek

[Former Member]

Have you followed the TMS settings as per the charm guide?

Moreover check SLG1 and see if any errors are there?

[Former Member]

can you please confirm whether DEV system got refreshed recently after creating this project

[Former Member]

Hi abhishek

Try and create a project manually in your DEV system. Go to spro_admin and create it. Let me know if you get any errors there. Also look at your DEV system for any dumps ST22. Try activating Charm in solman for that project again and then look at ST22 on DEV. Let me know the outcome of both.

[raquel_pereiradacunha]

Hi,

Try clicking Refresh in the same tab where you activated ChaRM. Then Check again.

Regards,

Raquel

[Former Member]

Tried ..but not working.