on 02-22-2013 10:28 AM
Hello,
In the MM SUS Scenario, I need to set the tolerance check for the PO in SUS. I already did the config in Set tolerance in SUS for BUS2230 (Tolerance Key- PM) and assign to the root vendor master but its not of use.
Currently supplier can confirm for over and under quantity in SUS and send the PO response .
My requirement is confirmed quantity should be check to the ordered quantity, and if the Confirmed quantity is less / more than the ordered quantity error message should be set.
Appreciate your pointers on this..
Hello,
To make a quantity toleance development you also can write your own code in BBP_DOC_CHECK_BADI for BUS2230 using standard tolerance fields.
Sorry to suggest you make a custom development when standard behaviour would be your solution but I tested it a time ago and cannot find a solution to make it work properly.
Regards,
SG
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.